How to Replace Paragon Binding on Lightning/Revo Ascent

By Therm-a-Rest® - Sleeping Pads, Bags & Outdoor Comfort | Published: 2026-10-30

Category: How-to Guides

Learn how to replace the Paragon binding on MSR Lightning Ascent and Revo Ascent snowshoes with this step-by-step guide, including common mistakes and tips.

Quick Answer

To replace the Paragon binding on your MSR Lightning Ascent or Revo Ascent snowshoes, remove the old binding and install the genuine Paragon replacement, which is designed as a direct fit for these models.

When to Replace Your Binding

Over time, snowshoe bindings can wear out or become damaged from regular use, especially in rough terrain. If your Paragon binding is no longer holding your boot securely, or if you notice cracked or broken components, it's time for a replacement.

Using a damaged binding can compromise your safety and reduce your control on the trail. Replacing it with a genuine Paragon binding ensures a proper fit and reliable performance, helping you maintain confidence in your snowshoes.

What You'll Need

Before you start, gather a flat-head screwdriver or a similar prying tool, and have your new Paragon binding ready. The replacement process is straightforward and doesn't require specialized skills.

Make sure you have the correct side (left or right) for your snowshoe, as Paragon bindings are available for both men's and women's sizes.

Step-by-Step Replacement Process

Remove the Old Binding: Using a flat-head screwdriver, gently pry the old binding off the snowshoe deck. Start at one edge and work around the perimeter to avoid damaging the deck. Checkpoint: Inspect the deck for any cracks or damage before installing the new binding.
Position the New Binding: Place the new Paragon binding over the mounting holes on the snowshoe deck, aligning it with the correct side (left or right) for your boot. Checkpoint: Ensure the binding is oriented so the heel strap will sit correctly under your boot.
Secure the Binding: Press down firmly on the binding until it snaps into place. Make sure all clips or fasteners are fully engaged. Checkpoint: Give the binding a gentle tug to confirm it is securely attached.
Test the Fit: Place your boot in the binding and tighten the straps as you normally would. Walk a few steps to ensure the binding holds your boot securely and feels comfortable. Checkpoint: If the binding slips or feels loose, re-check the installation and adjust the strap tension.

Genuine Paragon Binding

Paragon™ Binding - Lightning/Revo Ascent Snowshoes: These Paragon bindings are designed as a direct replacement for MSR Lightning Ascent and Revo Ascent snowshoes. You get a secure fit and reliable performance without needing to modify your snowshoes.
Paragon™ Binding - Lightning/Revo Ascent Snowshoes