How to Replace the DuoFit Binding on Evo Trail Snowshoes

By Therm-a-Rest® - Sleeping Pads, Bags & Outdoor Comfort | Published: 2026-10-25

Category: How-to Guides

Learn how to replace the DuoFit binding on your MSR Evo Trail snowshoes with this step-by-step guide. Restore fit and function quickly with simple tools.

Quick Answer

Replacing the DuoFit binding on your MSR Evo Trail snowshoes is a straightforward repair that restores fit and function. You'll need a flathead screwdriver and about 10 minutes per snowshoe.

Why Replace the Binding Instead of Buying New Snowshoes?

The DuoFit binding is a wear-and-tear item that takes the brunt of each step. Replacing just the binding costs a fraction of a new pair of snowshoes and keeps your trusted Evo Trail frames in service. MSR sells the binding individually for left or right, so you only replace the side that needs it.

What You'll Need

A flathead screwdriver is the only tool required. The replacement binding (sold individually for left or right) comes with all necessary hardware. Work on a clean, dry surface and have a small container handy for screws.

Step-by-Step DuoFit Binding Replacement

Step 1: Remove the Old Binding: Use a flathead screwdriver to pry out the plastic retaining pins that hold the binding to the snowshoe frame. Work from the heel toward the toe, lifting the binding away from the frame. Keep all pins and screws in a container. Common mistake: Forcing the pins out of order can crack the plastic. Always start at the heel end.
Step 2: Align the New Binding: Position the new DuoFit binding over the mounting holes on the snowshoe frame. Make sure the left/right orientation matches the side you are replacing — the binding is side-specific. Check the underside of the binding for a small L or R marking to confirm orientation before inserting pins.
Step 3: Secure the Binding: Press the retaining pins back into place through the binding and frame holes. Use your thumbs to push firmly until each pin snaps into the locked position. Give each pin a gentle tug to verify it's seated. A pin that isn't fully seated may pop out on the trail. Double-check each one before moving on.
Step 4: Test the Fit: Step into the snowshoe and tighten the DuoFit straps as you normally would. Walk a few steps indoors to confirm the binding holds your boot securely and the heel lift (if equipped) engages smoothly. If the binding feels loose or shifts side to side, one of the retaining pins may not be fully locked. Remove and re-seat it.

Replacement Part Used in This Guide

DuoFit™ Binding - Evo Trail Snowshoes: Replace the bindings on your Evo Trail snowshoes with these DuoFit bindings from MSR. Designed as a direct replacement part, this binding helps restore the fit and function of your snowshoes. Sold individually for the left or right side, so you can replace just the side you need. You don't have to buy a full set — if only one binding is worn, you save money and reduce waste by replacing just that side.
DuoFit™ Binding - Evo Trail Snowshoes